Wpilib screensteps live6/11/2023 Update the Roborio Image using the Roborio Imaging Tool instructions: **()** ** If successful, the tool will indicate the version of Roborio image loaded, and if none, can reimage the Roborio. Update Roborio firmware first following these instructions:ġ5. When connected via USB, the PC driver should install automatically, and the Roborio should be accessible via web browser at IP address 172.22.11.2. Make sure the ethernet cable is DISCONNECTED. Updating Roborio firmware and Imaging the Roborio.ĭownload and Install the National Instruments FRC 2015 Update on the PC to be used in connecting to the Roborio (dev PC, Driver Station, etc) - ** **3.Ĭonnect only the USB cable between Roborio and PC. Perform a factory reset on the Wifi Radio (hold recessed button in for greater than 10 sec). Uci set _option=”1, 255.255.255.0 28,**10.17.78.255”Ĭonnect power cabling to the Roborio and Wifi Radio.Ĭonnect Ethernet cable between Roborio and Wifi Radio.Ĭonfigure Wifi radio switch for wireless (not bridge) operation. To enable stdout for debugging after reconfiguring, reset the subnet mask on the radio:ĥ. IP: 10.17.78.1 Login: root Password: root SSH and log into the OpenMesh radio using a tool like PuTTY
0 Comments
Leave a Reply. |